Use OUTDOOR10 For 10% Off All Products
Design your own

One Piece Chaise Cushion.

Full length lounger cushion in one hinged piece.

This designer is not finished yet. Its product codes have not been set in custom/designers.json, so it cannot be priced or ordered. Every field below works, and the Add button stays off until the codes are filled in and CodesConfirmed is set to true.

Measurements

Measure the frame, not an old cushion - a cushion that has been sat on for five years is smaller than it started. The seat and the back are measured separately; we add them together and fold the cushion where they meet.

Front edge to the fold.
The fold to the top.
Overall length, seat plus back: 0 in. This is the figure that has to fit your chair.

Corners

Leave these at zero for square corners. Set a radius to round them - measure across from where the curve starts to where it ends, then halve it.

The corners, not the back section above.

Ties

Ties hold the cushion against the frame. Pick the arrangement that matches where your furniture has rails to tie to.

Fabric

Every fabric here is a solution dyed acrylic made to live outside. Order a sample if you want to see it in your own light first.